WIZnet Network Module with Mag Jack - WIZ830MJ

รหัสสินค้า : WIZNMwMJ-WIZ830MJ

WIZnet's WIZ830MJ is essentially a breakout board for their W5300 TCP/IP hardwired chip. Also featured on the board is an RJ-45 MagJack connector (RJ45 with X’FMR). It can be used as a component and little effort is required to interface to the W5300. The WIZ830MJ is an ideal option for users who want a simple solution to adding TCP/IP capability to their project.

There is no on-board regulation, so you'll need to supply clean/regulated 3.3VDC and 1.8VDC power sources. All pins of the W5300 are broken out to two pairs of 14 pin, 0.1" pitch headers.For detailed information on implementation of Hardware TCP/IP, refer to the W5300 Datasheet.

Features:

•    - Integrated W5300 TCP/IP hardware chip and MagJack connector
•    - All pins of the W5300 broken out to 0.1" pitch headers
•    - Supports 10/100 Base TX
•    - Operates 3.3V with 5V I/O signal tolerance
•    - High network performance: up to 50Mbps
•    - Supports half/full duplex operation
•    - Supports auto-negotiation and auto cross-over detection
•    - IEEE 802.3/802.3u Compliance
•    - Supports network status indicator LEDs
•    - Includes Hardware Internet protocols: TCP, IP Ver.4, UDP, ICMP, ARP, PPPoE, IGMP
•    - Includes Hardware Ethernet protocols: DLC, MAC
•    - Supports 8 independent connections simultaneously
•    - Supports MCU bus Interface
•    - Supports Direct/Indirect mode bus access
•    - Supports 16/8 bit data bus width
•    - Supports memory-to-memory DMA (only 16bit Data bus width & slave mode)
•    - Supports Socket API for easy application programming
•    - Supports hybrid TCP/IP stack(software and hardware TCP/IP stack)
•    - Supports PPPoE connection (with PAP/CHAP Authentication mode)
•    - More flexible allocation internal TX/RX memory according to application throughput
•    - Interfaces with two 2.54mm pitch 2 x 14 header pin

Dimensions: Board: 53.3x34.0x19.5 mm (W x D x H)